Connecting The Ac Power Cord - Christie DHD800 User Manual

Connecting the AC Power Cord

This projector uses nominal input voltages of 100-240 V AC.
It is designed to work with single-phase power systems
having a grounded neutral conductor. To reduce the risk of
electrical shock, do not plug into any other type of power
system.
If you are not sure of the type of power being supplied,
consult your authorized dealer or service station.
Connect the projector with all peripheral equipment before
turning on the projector.
2 types of fixing brackets are provided to prevent the AC power
cord from coming loose. Confirm your AC plug type with the
chart below and use the proper type of fixing bracket.
Follow these steps to attach the fixing bracket and connect the
AC power cord to the projector.
1
Fit a fixing bracket in each hole.
2
Connect the AC power cord to the projector.
3
Turn the fixing bracket to lock the AC power cord in place.
(See the right figure.)
Note:
• Unplug the AC power cord or turn off the MAIN ON/
OFF Switch when the projector is not in use. When the
projector is in stand-by mode, it consumes a little electric
power.
NOTE ON THE POWER CORD
AC power cord must meet the requirements of the country where you use the projector.
Confirm the AC plug type with the chart below and proper AC power cord must be used.
If the supplied AC power cord does not match your AC outlet, contact your sales dealer.
AC Outlet side
For the U.S.A. and Canada
Ground
To the AC Outlet.
(120 V AC)
For Continental Europe
DHD800 User Manual
020-000244-01 Rev.1 (08-2010)
Projector side
To the AC Outlet.
(200–240 V AC)
Holes
CAUTION
The AC outlet must be near this equipment and
must be easily accessible.
To POWER CORD
CONNECTOR on your
projector.
To POWER CORD
CONNECTOR on your
projector.
Installation
Fixing
bracket
Fixing Bracket
Part No. 610 342 7744
(Narrow)
Part No. 610 342 7751
(Wide)
23