Table of Contents
Advertisement
Display Controller Installation
Turn on the display(s) and then your computer.
12.
Turning on your system
WARNING - Turn on your display(s) before you turn on
your computer. Failure to do so could damage your dis-
play(s).
If you have properly installed your graphics card, the Windows
start-up messages will appear once the boot procedure is
finished.
Note: Your Barco display(s) will be running in a basic video
mode at a default refresh rate. Higher resolutions and refresh
rates, such as 1536x2048@60Hz, are not available at this stage
of the installation. Once you have installed the B
Display System drivers and software, the Barco monitor Plug and
Play software should automatically set the resolution for the
displays.
Install the drivers, QAWeb software and documentation for your
13.
B
C
ARCO
ORONIS
Driver and Software Installation section of this manual.
36
Display System by following the instructions in the
C
ARCO
ORONIS
Advertisement
Table of Contents
