Single-head installation
To attach the panel unit to the display stand:
Take the display stand from the packaging and put it on a solid
1.
flat surface.
Take the panel unit from the packaging and hold it in portrait
2.
position. The I-Guard should be positioned bottom right.
Hook the top gaps in the rear of the panel over the top anchors
3.
of the stand attachment plate (1). see figure 17.
Push the bottom of the panel firmly towards the stand so that
4.
the bottom anchors clip in the bottom gaps (2).
Check that the panel is firmly attached to the stand.
5.
2
1
Figure 17: Attaching the panel to the display stand
Single-head installation
3
4
45