Table of Contents
Advertisement
Step 10. Raise the Canopy over the Hanger Bracket.
Align the partially installed screws with the key slots
in the canopy.
Step 11. Twist the Canopy clockwise to secure.
Step 12. Install the third & fourth canopy screws in
the round holes on Canopy. Securely tighten all four
screws.
Step 13. Using both hands, push the Canopy Trim
ring up to the top of the Canopy.
Step 14. Twist the Canopy Trim ring clockwise to
secure it to the Canopy.
Step 1. On the motor, remove the five shipping
blocks by unscrewing the screws. Discard the
shipping blocks.
CAUTION:
Do NOT discard the Blade Iron
Screws. They will be used for
Blade Installation.
Blades (5)
Not Included
Step 1. Attach a blade to a blade iron by first
pressing the blade iron onto the blade, then attaching
the blade iron using 3 blade screws and blade
washers as shown in Figure #1. Using a phillips head
screwdriver, tighten securely by hand only. Repeat
for each blade assembly.
P
®
anama
REMOVE SHIPPING BLOCKS
BLADE HARDWARE
Blade
Blade Irons (5)
Washers (16)
BLADE INSTALLATION
E
s
nErgy
Round
Hole
Blade
Screws (16)
Screws (11)
Blade Screws
Blade Washers
Blade
FIGURE 1.
tar
Keyhole Slot
Blade Iron
Blade Iron
13
Advertisement
Table of Contents
