Table of Contents
Advertisement
Step 3.
Slide the Canopy, and Trim Ring on to
the downrod, then route the wires through the 3.5"
Perma•Lock downrod and ball assembly as shown in
Figure #3.
Step 4.
Insert the downrod into the motor coupling
and turn it clockwise until it stops turning, ensuring
that the downrod has bottomed out. Figure 4.
Tip: The downrod has a tapered thread that is
designed to lock completely when installed correctly.
P
E
®
anama
PERMA•LOCK™
DOWNROD AND
BALL ASSEMBLY
Trim Ring
s
nErgy
tar
FIGURE 3.
CAUTION: Failure to fully lock in the
downrod before securely tightening the
Set Screw may cause the fan to separate
from the downrod and fall during normal
operation.
FIGURE 4.
MOTOR WIRES
(LEAVE AT LEAST
6" LONG)
Canopy
MOTOR
COUPLING
9
Advertisement
Table of Contents
