Blade/Blade Holder Installation; Completing Installation; Install Switch Housing - Casablanca Key Largo II Manual

Step 9. Using the blade holder screws, attach
each blade/bladeholder assembly to the motor
with the bamboo stitch facing down.
Using the screwdriver, tighten securely by hand
only.
WARNINg! To reduce the risk of per-
sonal injury, do not bend the blade
brackets when installing the brackets,
balancing the blades, or cleaning the
fan. do not insert foreign objects in
etween rotation fan blades.
SWITCH HOUSINg
Step 10a. Install the two 6-32 X
onto the switch housing plate, leaving ap-
proximately " of the threads exposed for
1/
8
installation of the switch housing.
Step 10b. Line up the two inner clearance
holes in the cup with the two screws installed
in previous step.
CAUTION! Before continuing to the
next step check that a wire or compo-
nent inside the switch housing will
not be pinched as it is installed.
Step 10c. Plug the wire connector for the
fan into the wire connector for the switch
housing. Assure that the clip from the fan
connector engages the notch on the switch
housing connector.
NOTCH
Step 10d. Rotate cup so that the screws are
aligned with the smaller side of the clearance
holes. Tighten securely by hand only.
8

BLADE/BLADE HOLDER INSTALLATION

COmpLETINg INSTALLATION

CAp

INSTALL SWITCH HOUSINg

/ screws
3 "
8
CLIp
BLADE HOLDER
SCREWS(2 per blade)
SWITCH HOUSINg
mOUNT SCREW
SWITCH
HOUSINg
pLATE
SWITCH HOUSINg
mOUNT SCREW
6-32 X / "
3
8
(2)
6-32 X / "
3
8
(2)