Table of Contents
Advertisement
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located
where you wish to place your Casablanca fan,
an approved ceiling fixture outlet box must be
installed and wired.
WARNING!
To reduce the risk of fire, electrical shock, or
personal injury, mount to outlet box marked
"Acceptable Fan Support of 22.7 kg (50
lbs.) or less" using the mounting hardware
provided with the outlet box or directly to
structure.
CEILING HARDWARE (not to scale)
Mounting Bracket
Note: After removing the old fixture, check the
outlet box to insure that it is supported by a joist
or beam across its upper surface. If not, a 2 x4
stud must be installed.
Step 1. Drill two pilot holes into the wood support
structure through the outermost holes in the outlet
box. The pilot holes should be 9/64" in diameter.
Step 2. Thread the lead wires from the outlet box
down through the hole in the middle of the ceiling
plate.
WARNING!
Support directly to building structure
only.
P
anama
FAN INSTALLATION
GETTING STARTED
MOUNTING BRACKET INSTALLATION
E
®
nErgy
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either
the circuit breaker or fuse box), lower the old
fixture and disconnect the wiring. Check the
ceiling fixture outlet box to be sure it is marked
"Approved for Ceiling Fan Mounting. " If it is not, a
new box must be installed.
Note: The weight of this fan is 23 pounds.
#8 Wood Screw and Washer (2)
#10 Wood Screw (2)
s
tar
7
Advertisement
Table of Contents
