Table of Contents
Advertisement
English
Unpacking
The package should include the following items:
- Handset
- Base unit
- 2 batteries
Models 5035+1/5045+1 are also supplied with an extra handset including batteries, base unit
and mains adapter.
Connection
1. Connect the mains adapter to the Y socket of the base unit and to an electrical
wall socket.
2. Remove the battery cover from the back of the handset. Insert the batteries into the
handset ensuring correct battery polarity is observed. Replace the battery cover.
3. Place the handset in the base unit, with the keypad facing outwards. Once the
handset is correctly placed in the base unit, a beep will be heard and the battery
charge indicator
4. Charge the handset batteries without interruption for 24 hours initially (thereafter
fully discharged handset batteries will take up to 14 hours to recharge).
5. ONCE CHARGED, connect the telephone line cord to the socket marked T on
the underside of the base unit and then to a telephone network wall socket.
6. A click will be heard when the modular plug is correctly connected.
7. To setup the answering machine (5045) please refer to pages 20-26.
Only for models with an extra handset (5045+1/5035+1):
8. Connect the mains adapter* to the Y socket of the charger pod and to an
electrical wall socket.
9. Remove the battery cover from the back of the handset. Insert the batteries into the
handset ensuring correct battery polarity is observed. Replace the battery cover.
10. Place the handset in the charger pod and charge the handset batteries without
interruption for 24 hours initially (thereafter fully discharged handset batteries will
take up to 14 hours to recharge).
11. Once charged if the range symbol in the display continually flashes please refer to
page 14, Register a New Handset or Base Unit.
IMPORTANT!
Under power failure conditions, this telephone will not operate. Please ensure that a separate telephone,
not dependent on local power, is available for emergency use. The earpiece of the handset may attract
small ferromagnetic objects such as staples and pins, care should be taken when placing the handset
near these items. Do not place the base unit in areas of high humidity or where it will be exposed to
direct sunlight or other major heat sources.
*Only use the supplied power adapter: UK: 3513-0609-4AC or 0650100DB
AUS: 3513-0609-3AC or 0650100DA.
4
Installation
in the display will begin to flash.
- Mains adapter
- Line cord
www.doro.com
Advertisement
Table of Contents
