Table of Contents
Advertisement
Handset Paging
Pressing
on the base unit will activate the paging signal of the handset.
j
This function is used to help locate the handset or to page the person carrying the
handset. The signal will continue until the
The page can also be cancelled by pressing
Timer
Within approximately 5 seconds after the connection of a call, a timer will be shown
on the display. The timer helps you keep track of how long the call lasts.
Hands Free Function
The hands free button
front of the handset (5045).
If you wish, you can switch between handset and hands free during a call.
1. Enter the required telephone number.
2. Press
. When the call has been connected press
o
will be activated and the conversation can be heard through the speaker.
3. Place the handset vertically on an even surface, e.g. a table.
4. Speak towards the microphone located on the front edge of the handset, ensuring
that you are not further than 1 meter (3 feet) away from the handset during
the call.
5. If you want to adjust the speaker volume repeatedly press
will cycle through +=low, ++=high and off settings. To reactivate hands free
press
again.
s
6. Press
to terminate the call.
o
Please note!
Please remember that in hands free speaker mode, it is only possible for only one person at a time to
talk. The switch over between speaker and microphone is automatic and dependant on the sound level
of the incoming call and the microphone respectively.
It is therefore essential that there are no loud noises in the immediate surroundings of the telephone,
as this will disrupt the speaker function.
www.doro.com
Operation
is located on the back of the handset (5035), and on the
s
on the handset is pressed.
i
on the base again.
j
. The hands free feature
s
English
the display
s
9
Advertisement
Table of Contents
