Procedure To Override The Immobilizer Using The Throttle Twistgrip - Ducati SPORT 1000 S Owner's Manual

Procedure to override the immobilizer
using the throttle twistgrip
1) Turn the key to ON, turn the twistgrip to fully open
the throttle and hold it open.
The EOBD warning light (7, fig. 4.1) goes off after the
pre-set time of 8 seconds.
2) Release the throttle as soon as the EOBD warning
E
light turns off.
3) The EOBD warning light will light up and start flashing.
Now enter the electronic release code shown on the
CODE CARD given to the customer when the
motorcycle was handed over by the dealer.
4) Count the number of flashes of the EOBD (7, fig. 4.1)
light equal to the first number of the secret code.
Open the throttle twistgrip, keep fully open for
2 seconds, then release. The digit entered is
acknowledged, and the EOBD warning light comes on
and stays on for the pre-set time of 4 seconds. Repeat
the operation until you have entered the final digit. If no
operation is performed with the throttle twistgrip, the
EOBD light will flash 20 times and then illuminate
steadily. In this case, repeat the procedure from step (1).
5) When you release the throttle, if the code was entered
correctly, the EOBD light will flash to indicate that the
engine is unlocked. The EOBD light returns to its
normal state (off) after 4 seconds.
6) If the code was NOT entered correctly, the EOBD light
will remain lit and the procedure can be repeated as
many times as necessary by turning the key to OFF,
then starting again from step (1).
18
Notes
If you release the twistgrip too soon, the warning light
comes on again. Return the ignition key to OFF and repeat
the procedure from step 1.