Throttle Twistgrip; Procedure To Override The Immobilizer Using The Throttle Twistgrip - Ducati MONSTER 695 Use And Maintenance Manual

Procedure to override the immobilizer
using the throttle twistgrip
1) Turn the key to ON, fully open the throttle and hold it
open.
The EOBD warning light (7, fig. 4.1) will go off after the
pre-set time of 8 seconds.
2) Release the throttle as soon as the EOBD warning light
E
turns off.
3) Now enter the electronic release code shown on the
CODE CARD given to the customer when the
motorcycle was handed over by the dealer. The EOBD
warning light will light up and start flashing.
Count the number of flashes of the EOBD (7, fig. 4.1)
light equal to the first number of the secret code.
Turn the throttle twistgrip to the fully open position: the
digit entered is acknowledged, and the EOBD warning
light comes on and stays on for the pre-set time of
4 seconds.
If no operation is performed with the throttle twistgrip,
the EOBD light will flash 20 times and then illuminate
steadily. In this case, repeat the procedure from step (1).
4) Release the throttle as soon as the EOBD warning light
turns off.
5) Repeat the operations in steps 3 and 4 until the last digit
has been entered.
6) When you release the throttle, if the code was entered
correctly, the EOBD light will flash to indicate that the
engine is unlocked. The EOBD light returns to its normal
state (off) after 4 seconds. If the code was NOT entered
correctly, the EOBD light will remain lit and the
procedure can be repeated as many times as necessary
by turning the key to OFF, then re-starting from step (1).
18
Notes
If you release the twistgrip too soon, the warning light
comes on again. Return the ignition key to OFF and repeat
the procedure from step 1.