Procedure To Disable Immobilizer Engine Block Through Throttle Twistgrip - Ducati 749S 2005 Owner's Manual

Procedure to disable immobilizer engine block
through throttle twistgrip
1) Turn the key to ON and fully open the throttle. Hold it in
this position.
The EOBD warning light (8, fig. 4) turns off after 8 seconds.
2) Release the throttle as soon as the EOBD warning light
turns off.
E
3) The EOBD pilot light will flash. Now enter the electronic
release code shown on the CODE CARD given to the
customer at the time of consignment of the motorcycle
by the dealer.
4) Count a number of flashes of the EOBD light (8, fig. 4)
equivalent to the first number of the secret code. Open full
throttle and keep the position for 2 seconds, then release.
In this way the input of one figure is acknowledged, the
EOBD warning light comes on and stays on for 4 seconds.
Repeat the operation until you have entered the final digit. If
you fail to perform any operation with the throttle the EOBD
light will flash 20 times and then illuminate steadily to inform
you that the procedure must be repeated from step 1.
5) When you release the throttle, if the code was inserted
in the correct way, you can have two situations, A or B:
A) the EOBD light starts flashing to indicate that engine is
enabled. The light switches off after 4 seconds, or if
engine speed exceeds the threshold value of 1000 rpm.
B) the CODE (12, fig. 5) light flashes until engine rpm
exceeds 1000 rpm or until the vehicle is restarted.
6) Should the code NOT be entered correctly the EOBD and
CODE lights remain lit and the procedure can be repeated
starting from step 2 for as many times as necessary.
22
Notes
Should the throttle twistgrip be released before the
set time, the warning light turns on again.
It is then necessary to bring the key to OFF and restart the
procedure from point (1).