Procedure To Override The Immobilizer Using The Throttle Twistgrip - Ducati SPORTCLASSIC GT 1000 TOURING Owner's Manual

Procedure to override the immobilizer
using the throttle twistgrip
1) Turn the key to ON, turn the twistgrip to fully open
the throttle and hold it open.
The EOBD warning light (7, fig. 4.1) goes off after the
pre-set time of 8 seconds.
2) Release the throttle as soon as the EOBD warning
light turns off.
3) Now enter the electronic release code shown on the
CODE CARD given to the customer when the
E
motorcycle was handed over by the dealer. The EOBD
warning light will light up and start flashing.
Count the number of flashes of the EOBD (7,fig. 4.1)
light equal to the first number of the secret code.
Turn the throttle twistgrip to the fully open position:
The digit entered is acknowledged, and the EOBD
warning light comes on and stays on for the pre-set time
of 4 seconds. If no operation is performed with the
throttle twistgrip, the EOBD light will flash 20 times
and then illuminate steadily. In this case, repeat the
procedure from step (1).
4) Release the throttle as soon as the EOBD warning
light turns off.
5) Repeat the operations in steps 3 and 4 until the last
digit has been entered.
6) When you release the throttle, if the code was entered
correctly, the EOBD light will flash to indicate that the
engine is unlocked. The EOBD light returns to its
normal state (off) after 4 seconds. If the code was NOT
entered correctly, the EOBD light will remain lit and the
18
procedure can be repeated as many times as necessary
by turning the key to OFF, then re-starting from step (1).
Notes
If the throttle twistgrip is released before the pre-set
time, the EOBD light comes on again, and it will be
necessary to turn the key to OFF and repeat the
procedure from step (1).