Table of Contents
Advertisement
2.1.5 Wiring the Fault Alarm Contact
The fault alarm contacts are in the middle of the terminal block
connector as the picture shows below. Inserting the wires, the
Industrial Gigabit Media Converter will detect the fault status of the
power failure and then forms an open circuit. The following illustration
shows an application example for wiring the fault alarm contacts.
1
Fault Alarm Contacts
Insert the wires into the fault alarm contacts
The wire gauge for the terminal block should be in the
range between 12 and 24 AWG.
Note
2.1.6 Cabling
10/100/1000Base-T and 100Base-FX / 1000Base-SX/LX
The 10/100/1000Base-T port comes with Auto-Negotiation capability.
It automatically supports 1000Base-T, 100Base-TX and 10Base-T
networks. Users only need to plug a working network device into
the 10/100/1000Base-T port, and then turn on the Industrial Gigabit
Media Converter. The port will automatically runs in 10Mbps, 20Mbps,
100Mbps or 200Mbps and 1000Mbps or 2000Mbps after the negotiation
with the connected device.
16
2
3
4
5
Fault
6
The Fault Alarm Contacts are
energized (CLOSE) for normal
operation and will OPEN when
failure occurs
Advertisement
Table of Contents
