Planet IGT-1205AT User Manual page 27

Installation Steps
Step 1: Unpack the Industrial Gigabit Media Converter.
Step 2: Check whether the DIN-Rail is screwed on the Industrial
Gigabit Media Converter. (Please refer to DIN-Rail Mounting
section for DIN-Rail installation if the DIN-Rail is not screwed
on the Industrial Gigabit Media Converter). If you want to
wall-mount the Industrial Gigabit Media Converter, then
please refer to the Wall Mount Plate Mounting section for wall
mount plate installation.
Step 3: To hang the Industrial Gigabit Media Converter on the
DIN-Rail
Installation section.
Step 4: Power on the Industrial Gigabit Media Converter. (Please refer
to the Wiring of the Power Inputs section for power input)
The power LED on the Industrial Gigabit Media Converter will
light up. Please refer to the LED Indicators section for the
functions of LED lights.
Step 5: Prepare the twisted-pair, straight through Category 5 cable
for Ethernet connection.
Step 6: Insert one side of category 5 cable into the Industrial Gigabit
Media Converter Ethernet port (RJ-45 port) while the other
side of category 5 cable into the network devices' Ethernet
port (RJ-45 port), ex: switch, PC or server. The UTP port
(RJ-45) LED on the Industrial Gigabit Media Converter will
light up when the cable is connected with the network device.
Please refer to the LED Indicators section for the functions of
LED lights.
Step 7: When all connections are all set and LED lights all show
normally, the installation is complete.
Be sure the connected network devices support MDI/
MDI-X. If it does not
category 5 cable.
Note
track or wall,
support,
please refer to
then use the crossover
the Mounting
27