Wiring The Fault Alarm Contact - Planet IGT-805AT User Manual

The wire gauge for the terminal block should be in the
range between 12 and 24 AWG.
Note

3.4 Wiring the Fault Alarm Contact

The fault alarm contacts are in the middle of the terminal block
connector as the picture shows below. When inserting the wires, the
Industrial Gigabit Media Converter will detect the fault status of the
power failure and then forms an open circuit. The following illustration
shows an application example for wiring the fault alarm contacts.
1
Fault Alarm Contacts
Insert the wires into the fault alarm contacts
The wire gauge for the terminal block should be in the
range between 12 and 24 AWG.
Note
22
2 3 4 5
Fault
6
The Fault Alarm Contacts are
energized (CLOSE) for normal
operation and will OPEN when
failure occurs