Table of Contents
Advertisement
2. Make sure both sides of the SFP transceiver are with the same
media type or WDM pair; for example, 100Base-FX to 100Base-FX,
100Base-BX20-U to 100Base-BX20-D.
3. Check the fiber-optic cable type match the SFP transceiver model.
To connect to MFB-FX SFP transceiver, use the multi-mode fiber
cable with one side being the male duplex LC connector type.
To connect to MFB-F20/F40/F60/FA20/FB20 SFP transceiver, use
the single-mode fiber cable with one side being the male duplex
LC connector type.
Connect the fiber cable
1. Attach the duplex LC connector on the network cable to the SFP
transceiver.
2. Connect the other end of the cable to a device, switches with SFP
installed, to fiber NIC on a workstation or a Media Converter.
3. Check the LNK/ACT LED of the SFP slot of the switch / converter.
Make sure that the SFP transceiver is operating correctly.
2.1.6.2 Remove the Transceiver Module
1. Make sure there is no network activity by consulting or checking with
the network administrator. Or through the management interface of
the switch/converter (if available) to disable the port in advance.
2. Remove the Fiber Optic Cable gently.
3. Turn the lever of the MGB/MFB module to a horizontal position.
4. Pull out the module gently through the lever.
MGB / MFB Series
Transceiver
Figure 2-4: Pulling Out from the Transceiver
2
1
21
Advertisement
Table of Contents
