Setting The Acoustic Signal - Electrolux ESF6281 User Information

Setting the amount of rinse aid re-
quired
3
Only change the amount dispensed, if smears,
milky spots (reduce the amount) or dried on
water spots (increase the amount) can be seen
on glasses and dishes. (See section "If dish-
washing results are not satisfactory".) The
dosage can be set from 1-6. The dosage is
pre-set to "4" in the factory.
1. Open the dishwasher door.
2. Press the release button on the rinse aid compart-
ment.
3. Open the cover.
4. Set the dosage level.
5. Press the lid shut until it clicks into place.
6. If rinse aid has leaked out, wipe it away with a
cloth.

Setting the acoustic signal

In addition to the optical display (e.g. indicating the
end of the cycle, errors) you can also choose to set
an acoustic signal.
1. Press the ON/OFF button.
3
If the name of a programme stage is displayed
in the display, a dishwashing cycle is active.
First of all you must abort the dishwashing cy-
cle:
– Press the Cancel button. CONFIRM CANCEL?
appears in the display.
– Press the Ok/Start button. This cancels the dish-
washing cycle.
2. To go the BUZZER setting; see section "Adjusting
an option/setting".
3. To switch audible beep (BUZZER) on or off.
When the audible beep is switched off, the symbol
is lit in the display.
15