Fault Codes - Xerox Color 550 User Manual

SquareFold Trimmer Module

Fault codes

If a jam/fault occurs in the SquareFold Trimmer Module, the machine s UI displays a
jam/fault message. The following table provides a list of fault codes for the SquareFold
Trimmer Module and a list of related finisher fault codes.
Note
The top covers cannot be opened during normal operation or when the machine is idle.
The covers can be opened only when an indicator is lit and a jam/fault occurs within the
SquareFold Trimmer Module. For indicator details, refer to the control panel information
earlier in this section.
Fault Code Possible Cause
013-100 013-101 Jam/fault with the SquareFold
013-102 013-103 Trimmer Module
013-104 013-105
013-106 013-303
013-915 013-916
013-917 013-918
013-919
14-14
Recommended Solution
1. Open the Top Left and Right Covers
of the SquareFold Trimmer Module.
2. Carefully remove all sheets and
paper scraps from jam clearance
areas.
3. Close the SquareFold Trimmer
Module Top Left and Right Covers.
4. Check the Trimmer Waste Contain-
er:
If full, empty the container and
reinsert it into the SquareFold
Trimmer Module
If the container is partially pulled
out, push it completely in
5. If necessary, follow any remaining
instructions on the machine s UI.
6. If fault persists, repeat Steps 1-5; if
fault persists after that, call for ser-
vice.
Xerox Color 550/560/570 Printer
®
User Guide