General Source Controls - SMART Board Board 600iv Configuration And User's Manual

A P P E N D I X A
Remotely managing your interactive whiteboard system
The following table describes the source selection commands:
Command
get input
set input [field]
The following table describes the source selection response fields:
Field
VGA1
Composite
S-Video
None

General source controls

The following source controls apply to all input sources. These controls are unavailable when the
projector is in Standby mode. You can specify custom color values for all inputs.
These commands inform you of the current source settings.
Command
get displaymode
get brightness
get contrast
get whitepeaking
get degamma
get red
get green
get blue
get cyan
get magenta
get yellow
get videofreeze
61
Description
Returns the projector's current input.
Returns the input to one of the selectable fields.
Description
Switches source to the VGA 1 input connector.
Switches source to the Composite video connector.
Switches source to the S-Video input connector.
A non-selectable value that appears when you enter a "get input"
command while the projector is in Standby mode.
Response
displaymode=[current display mode setting]
brightness=[current brightness setting]
contrast=[current contrast setting]
whitepeaking=[current whitepeaking setting]
degamma=[current degamma setting]
red=[current red color setting]
green=[current green color setting]
blue=[current blue color setting]
cyan=[current cyan color setting]
magenta=[current magenta color setting]
yellow=[current yellow color setting]
videofreeze=[current video freeze setting]