Resetting The Lamp Timer - SMART Board Board 600iv Configuration And User's Manual

C H A P T E R 5
Maintaining your interactive whiteboard system
5. Replace the boom end cap.
6. Connect the cables to the projector.
7. Connect the power cable to a power outlet.
8. Press the Power
and that the lamp module is correctly installed, and then wait for the projector to turn on
completely.
9. Wait five minutes for the projector to warm up.
N
N O T E
You might need to adjust the projected image after you perform the previous procedures. For
more information, see the included SMART Board 480iv and 680iv Interactive Whiteboard
Systems Installation Guide (smarttech.com/kb/153153) and Adjusting the image on page 20.

Resetting the lamp timer

After you replace the lamp, you need to access the projector service menu and reset the lamp hour
counter. To prevent accidental errors, only a system administrator should perform this procedure.
N
N O T E
Always reset the Lamp Hours after you replace the lamp because lamp service reminders are
based on the current hours of use.
35
button once on the remote control to confirm that the projector is operating