SMART Board Board 600iv Configuration And User's Manual page 27

C H A P T E R 3
Using your interactive whiteboard system
Setting Use
Startup Screen Selects the type of startup screen
(SMART, Capture User Startup
Screen or Preview Startup Screen).
Set to Default? Resets projector settings to their
default values.
Network menu
Network Activates the network features.
Status Displays the current network status
(Connected, Disconnected or Off).
DHCP Displays the status of the network's
Dynamic Host Control Protocol
(DHCP) as On or Off.
Password E-mails the network password to the e-
Reminder mail recipient.
IP Address Displays the projector's IP address in
values between 0.0.0.0 and
255.255.255.255.
Sub Mask Displays the projector's subnet work
mask number in values between
0.0.0.0 and 255.255.255.255.
17
Notes
This screen displays when the
projector lamp is starting and an image
isn't displayed.
SMART displays the default SMART
logo on a blue background.
Capture User Startup Screen closes
the on-screen display menu and
captures the entire projected
interactive whiteboard image. The
captured image is displayed the next
time that the on-screen display opens.
(The capture can take up to one
minute, depending on the complexity of
the background graphic.)
Preview Startup Screen enables you
to preview the default or captured
startup screen.
If you select Yes, all projector settings
reset to their defaults, reversing any
menu changes you made. This action
is irreversible.
Don't adjust this setting unless you
want to reset all of the applied settings,
or unless you're advised to by a
certified SMART Support specialist
(smarttech.com/contactsupport).
On automatically assigns the DHCP
server's IP address to the projector.
Off enables an administrator to assign
an IP address manually.
See Web page management on page
52 to set up a destination e-mail
address.