System Controls - SMART Board Board 600iv Configuration And User's Manual

A P P E N D I X A
Remotely managing your interactive whiteboard system
These commands control your network settings.
Command
set dhcp [target]
set ipaddr [target]
set subnetmask [target]
set gateway [target]
set primarydns [target]

System controls

These commands enable you to switch system settings and access system information.
These commands inform you of the current system settings. These commands are unavailable when
the projector is in Standby mode.
Command
get autosignal
get lampreminder
get highbrightness
get autopoweroff
get zoom
get projectorid
get hposition
get vposition
get aspectratio
get projectionmode
get startupscreen
get resolution
get language
get groupname
get projectorname
get locationinfo
get contactinfo
get modelnum
get videomute
get 3denable
get 3dinvert
get 3dformat
get emergencyalertmsg
get emergencyalert
65
Command target range
=on
=off
=0.0.0.0 to =255.255.255.255
=0.0.0.0 to =255.255.255.255
=0.0.0.0 to =255.255.255.255
=0.0.0.0 to =255.255.255.255
Response
autosignal=[current auto signal detection setting]
lampreminder=[current lamp reminder setting]
highbrightness=[current lamp brightness setting]
autopoweroff=[current auto power off setting]
zoom=[current zoom setting]
projectorid=[current projector ID number]
hposition=[current horizontal position setting]
vposition=[current vertical position setting]
aspectratio=[current projector aspect ratio]
projectionmode=[current projection mode]
startupscreen=[current startup screen setting]
resolution=[current input resolution]
language=[current language setting]
groupname=[current projector group name]
projectorname=[current projector name]
locationinfo=[current projector location]
contactinfo=[current support contact information]
modelnum=[current model number]
videomute=[current video mute setting]
3denable=[current 3D feature setting]
3dinvert=[current 3D invert setting]
3dformat=[current 3D format]
emergencyalertmsg=[current emergency alert message]
emergencyalert=[current emergency alert setting]
Response
dhcp=[current]
ipaddr=[current]
subnetmask=[current]
gateway=[current]
primarydns=[current]