SMART Board Board 600iv Configuration And User's Manual page 4

I M P O R T A N T I N F O R M A T I O N
Do not leave cables on the floor where they can be a tripping hazard. If you must run a cable
l
over the floor, lay it in a flat, straight line and secure it to the floor with tape or a cable
management strip of a contrasting color. Handle cables carefully and avoid excessive
bending.
If you are using an RS-232 serial expansion module, a wireless Bluetooth® connection
l
expansion module or a USB audio system, use only the power supply included with that
product. These products do not use the same power supplies. Using the wrong power supply
might create a safety hazard or damage the equipment. If in doubt, refer to the specification
sheet for your product to verify the power supply type.
Do not climb (or allow children to climb) on a wall- or stand-mounted SMART Board
l
interactive whiteboard.
Do not climb on, hang from or suspend objects from the projector boom.
Climbing on the interactive whiteboard or projector boom could result in personal
injury or product damage.
There are no user-serviceable parts inside the pen tray. Only qualified personnel should
l
disassemble the pen tray's printed circuit boards, and this procedure must be done with
proper electrostatic discharge (ESD) protection.
For warnings related to the projector's 3D support, see smarttech.com/support/3Dwarnings.
l
C
C A U T I O N
Do not operate this unit immediately after moving it from a cold location to a warm location.
l
When the unit is exposed to such a change in temperature, moisture can condense on the
lens and crucial internal parts. Allow the system to stabilize to room temperature before
operation to prevent possible damage to the unit.
Do not place the unit in hot locations, such as near heating equipment. Doing so could cause
l
a malfunction and shorten the life of the projector.
Avoid setting up and using the SMART product in an area with excessive levels of dust,
l
humidity and smoke.
Do not place your SMART product in direct sunlight or near any appliance that generates a
l
strong magnetic field.
ii