SMART Board Board 600iv Configuration And User's Manual page 5

I M P O R T A N T I N F O R M A T I O N
If you need to lean the interactive whiteboard against a wall before you mount it, make sure it
l
remains in an upright position, resting on the pen tray brackets, which can sustain the weight
of the interactive whiteboard.
Do not rest the interactive whiteboard on its side or on the top of the frame.
You must connect the USB cable that came with your SMART Board interactive whiteboard
l
to a computer that has a USB compliant interface and that bears the USB logo. In addition,
the USB source computer must be compliant with CSA/UL/EN 60950 and bear the CE mark
and CSA and/or UL Mark(s) for CSA/UL 60950. This is for operating safety and to avoid
damage to the SMART Board interactive whiteboard.
Do not block the projector's ventilation slots and openings.
l
Avoid putting the projector into Standby mode during the lamp ignition phase because this
l
can lead to premature lamp failure. Keep the projector lamp on for a minimum of 15 minutes
before putting it into Standby mode to preserve the lamp life.
In a high altitude location over 1800 m (6000'), where the air is thin and cooling efficiency is
l
reduced, use the projector with the fan mode set to High.
Cycling power to the projector repeatedly can lock or damage your SMART product. After
l
you put the product into Standby mode, wait at least 15 minutes for cooling before starting
the product again.
Do not adjust any settings in the service menu other than those listed in the following
l
procedures. Changing other settings might damage or affect the operation of your projector
and invalidates your warranty.
If dust or small items prevent pen tray buttons from being pressed or cause constant button
l
contact, remove the obstructions carefully.
Before you clean the SMART V25 projector, press the Power
l
control or projector to put the system into Standby mode, and then allow the lamp to cool for
45 minutes.
Do not spray cleaners, solvents or compressed air near any part of the projector because
l
they can damage or stain the unit. Spraying the system could spread a chemical mist on
some of the projector's components and lamp, resulting in damage and poor image quality.
Do not allow liquids or commercial solvents of any kind to flow into the projector.
l
iii
button twice on the remote