Yealink SIP-T4X Provisioning Manual page 103

Integer
zero_touch.wa
it_time =
from 0 to 100
push_xml.serv
URL
er =
push_xml.bloc
0 or 1
k_in_calling =
push_xml.sip_
0 or 1
notify =
features.actio
IP addresses
n_uri_limit_ip
or any
=
features.actio
0 or 1
n_uri_reboot_
now =
during startup.
0-Disabled
1-Enabled
The default value is 0.
It configures the duration time (in
seconds) of the phone displaying the
zero-sp-touch configuration interface
when powered on.
The default value is 5.
It configures the URL of the push XML
server.
It enables or disables the phone to
block displaying the push XML
interface when in calling status.
0-Disabled
1-Enabled
The default value is 0.
It enables or disables the phone to use
the push XML via SIP NOTIFY message.
0-Disabled
1-Enabled
The default value is 0.
It configures the IP address of server
from which the phone receives the
action URI requests. Multiple IP
addresses are separated by commas.
If the value of this parameter is
configured as "any", the phone will
receive action URI requests from any IP
server.
It enables or disables the phone to
perform reboot during a call when
receiving a specific action URI request
about reboot.
0-Disabled
1-Enabled
The default value is 0.
Appendix
Active
Settings->Auto
Provision->Wait
Time
Features->Remote
Control-> Push XML
Server IP Address
Features->Remote
Control->Block
XML In Calling
Features-> Remote
Control->SIP Notify
Features-> Remote
Control->Action
URI allow IP List
97