Xerox DocuPrint 240A User Manual page 84

Ethernet
Sets the communication speed/connector type of the Ethernet interface.
[Auto] (default)
Select this to switch between 100BASE-TX and 10BASE-T automatically.
[100BASE-TX]
Select this to use 100BASE-TX only.
[10BASE-T]
Select this to use 10BASE-T only.
IPX/SPX Frame Type
Sets the operational frame type of IPX/SPX.
[Auto] (default)
Select this to automatically set the frame type.
[Ethernet II]
Select this to use the Ethernet frame type.
[Ethernet 802.3]
Select this to use the IEEE802.3 frame type.
[Ethernet 802.2]
Select this to use the IEEE802.3/IEEE802.2 frame type.
[Ethernet SNAP]
Select this to use the IEEE802.3/IEEE802.2/SNAP frame type.
Filter
IP Filter
Specifies whether to limit IP addresses that receive print jobs. Select [On] if you do not want
to receive print jobs from non-registered IP addresses. The default is [Off].
Note
• Even if [On] is set, it becomes invalid when all the registered IP addresses are "000.000.000.000".
IP Address
Registers the IP addresses that are allowed to receive jobs if you want to limit the IP
addresses. You can specify up to 10 IP addresses. Set the address masks for the registered
IP addresses. Enter the IP addresses and address masks in the format of xxx.xxx.xxx.xxx.
You can set values between 0 and 255 for xxx. For example, if you specfy "126.249.110.23"
in [IP Address] and "255.255.255.0" in [IP Address Mask], the addresses that are allowed
to receive jobs are "129.249.110.* (1 to 254)".
84
4 Settings on the Control Panel
*3 (refer to P. 94)