Xerox DocuPrint 240A User Manual page 111

Message
Paper Jam
Open Cover A
Please reboot
Printer xxx-xxx
Please wait...
Please wait...
xxxx
Printing...
xxxx
Printing...
xxxx Tray *
Pull out all
trays Clear jam
Clear jam and
close Cover A
Push in Tray *
Raise Rear
OutputTray lever
Ready to print
Ready to print
xxx-xxx
Ready to print
DNS Update Fail
Ready to print
Dupl. IP Address
Paper jam has occurred around the drum/toner cartridge.
When cover A is opened, the message "Remove cartridge Clear jam" will be
displayed. Follow the instruction to fix the error.
Refer to
• "5.1 When Paper Jams" (P. 100)
Error has occcurred.
Switch off the power. After the control panel display is turned off, switch on the power
again. If the same message appears again, take notes on the code "xxx-xxx". And
then switch off the power. After the control panel display is turned off, pull out the
power plug from the outlet and contact our Customer Support Center or your dealers.
Diagnosing/initializing the printer system. This is displayed when the power is
switched on or the system is reset. After a while, the message "Ready to print" is
displayed.
This also indicates that the printer is warming up to forcedly output the print data
remaining in the printer.
The printer cannot receive any print data from the computer during processing.
The printer is warming up to forcedly output the print data remaining in it. The printer
can receive the print data from a computer during processing.
The printer is processing the print data. The printer can receive print data from a
computer during processing.
The printer is outputting data on paper from tray * . Do not pull out the tray being
used. The printer can receive print data from a computer during processing.
Paper jam has occurred at the rear of the paper trays.
Pull out all the trays to remove jammed paper. And then, open and close cover A.
This will cancel the error.
Refer to
• "Inside Paper Tray" (P. 101)
Tray * is pulled out.
Push tray * completely into the printer.
Since the center output tray is set as the output destination, the printer cannot output
to the rear tray. Pull up the rear output tray lever and change the output destination to
the rear tray.
The printer is ready to receive print data from computers.
An error has occurred in the printer.
Switch off the power. After the control panel display is turned off, switch on the power
again. If the error code appears again, check the error code "xxx-xxx" displayed and
perform the appropriate procedures.
Refer to
• "List of Error Codes" (P. 113)
Unable to retrieve IP address from DNS.
Check the settings for DNS and retrieving IP address.
Refer to
• Online Help for CentreWare Internet Services
The IP addresses are duplicated.
Change the IP addresses.
Refer to
• Setup and Quick Reference Guide Setting IP Address
Condition/Reason/Action
111
5.4 Message List