Programmable Memory Scan (Pms); Registering To The Programmable Memory Channels - Yaesu FTM-3207D Advance Manual

Programmable Memory Scan (PMS)

The FTM-3207DR/DE can be set to tune or scan only the frequencies between user-
defined lower and band limits.
Example: Set up a PMS channel by registering a lower frequency of 443.300 MHz, and
an upper frequency of 447.000 MHz to the L1/U1 memory channels.

Registering to the programmable memory channels

1. In the VFO mode, select the desired lower-limit scan frequency (443.300 MHz).
2. Press and hold the [ V/M ( MW )] key for one
second.
A memory number will appear in the bottom
right corner of the display.
3. Within five seconds
[ V/M ( MW )] key, rotate the DIAL knob to se-
lect "L1".
Note: While operating in the Memory Storage mode, the keypad of the MH-48A6JA
Microphone may be used to enter the memory channel number directly.
To do this, enter the desired Channel Number (see table below) on the keypad
and then press the [ # ] key.
To enter Memory Channel "L1", press [ 2 ] à [ 0 ] à [ 1 ] à [ # ]
To enter Memory Channel "U0", press [ 2 ] à [ 2 ] à [ 0 ] à [ # ]
L1
U1
L2
U2
4. Press the [ V/M ( MW )] key again, momentarily, to store the displayed data into the
memory channel (L1).
5. Select the desired upper-limit scanning frequency (447.000 MHz).
6. Within five seconds
[ V/M ( MW )] key, rotate the DIAL knob to se-
lect "U1".
7. Press the [ V/M ( MW )] key again, momentar-
ily, to store the displayed data into the mem-
ory channel (U1).
FTM-3207DR/DE Advance Manual
of pressing
201 L3 205
202 U3 206
203 L4 207
204 U4 208
of pressing
VOL
SQL
TXPO
the
L5 209 L7
U5 210 U7
L6 211 L8
U6 212 U8
the
Scanning
DIAL
REV D/A M H z V / M
D W M W
SETUP
213 L9 217
214 U9 218
215 L0 219
216 U0 220
19