IAME REEDSTER 125cc Assembly Instructions & User Manual page 21

2.9.11 CONNECT THE STARTER RELAY TO
THE 4 POLES CONNECTOR
HARNESS (SEE FIG.31).
2.9.12 DRILL A Ø 22mm HOLE IN THE SIDE
EDGE OF THE FRONT
(ENGINE SIDE); AND INSTALL THE STARTER
ASSEMBLY (SEE FIG.32).
SECURE THE STARTER ASSEMBLY WITH THE
THREADED LOCKING NUT.
2.9.13 CONNECT THE STARTER ASSEMBLY
CONNECTOR TO THE 8 POLES CONNECTOR
ON THE HARNESS (SEE FIG.33).
ATTENTION:
MAKE SURE THAT THE FIXING TONGUE OF
THE CONNECTOR IS PROPERLY INSERTED
TO GUARANTEE THE
CONNECTION OF THE TERMINALS.
2.9.14
ATTACH THE DUAL-LOCK STRAP
UNDER THE FAIRING
STEERING COLUMN) AND
ELECTRONIC BOX AND
RELAY (SEE FIG. 34).
NOTE:
CLEAN AND DEGREASE
WHERE THE STRAP IS TO BE PLACED TO
GUARANTEE THE
ATTACHMENT.
FOR A BETTER FASTENING, SECURE THE
ELECTRONIC BOX AND
SCREWS, BY USING THE EXPRESSLY MADE
HOLES FOR THIS PURPOSE.
ON THE
Fig.31
PANEL FAIRING
Fig.32
BEST POSSIBLE
Fig.33
(CLOSE TO THE
INSTALL THE
THE STARTER
THE SURFACE
BEST POSSIBLE
RELAY WITH
Fig.34
19
Ø 22mm
MAN-051 ING