Table of Contents
Advertisement
2.9
ELECTRICAL CONNECTIONS
(refer
to
the
schematic)
NOTE :
For a correct installation follow the under
shown instructions.
2.9.1 INSERT THE BATTERY STRAP IN THE
BATTERY SUPPORT BOX (SEE FIG.19).
2.9.2 PLACE THE BATTERY SUPPORT BOX IN
THE FRONT OF THE CHASSIS (UNDER THE
FRONT PANEL FAIRING) AND FIX IT WITH THE
CLAMPS TO THE LOWER STEERING COLUMN
SUPPORT TUBES (M6x25 SCREWS - SEE
FIG.20).
TORQUE AT 8 ÷ 10 Nm (70 ÷ 90 in. Lb)
PIPE WRENCH - 10mm
THE SUPPORT BOX MUST BE FIXED WITH AT
LEAST ONE BOLT FOR EACH CLAMP. FIX THE
BOX
WITH
MORE
DEPENDING ON THE TYPE OF CHASSIS.
NOTE:
THE BOX AND CLAMPS ARE PROVIDED WITH
VARIOUS HOLES TO ALLOW INSTALLATION
ON ALL KIND OF CHASSIS.
2.9.3 INSERT THE BATTERY IN THE BOX AND
FASTEN IT WITH THE BATTERY STRAP (SEE
FIG.21).
POSITION THE BATTERY TERMINALS AS
SHOWN ON THE FIGURE.
ATTENTION :
PAY ATTENTION NOT TO SHORT-CIRCUIT
THE BATTERY TERMINALS AS THE BATTERY
COULD BE DAMAGED BEYOND REPAIR.
2.9.4
PLACE
THE
STARTING FROM THE ENGINE, ALONG THE
RAILS, THE STEERING COLUMN AND UNDER
THE FRONT PANEL FAIRING (SEE FIG.22).
TIGHTEN WITH PLASTIC CLAMPS.
ATTENTION:
NEVER LET THE HARNESS GET IN TOUCH
WITH THE GROUND OR WITH ROTATING
PARTS AS IT COULD BE DAMAGED BEYOND
REPAIR.
attached
electrical
THAN
ONE
BOLT
WIRING
HARNESS
Fig.19
Fig.20
Fig.21
Fig.22
16
MAN-051 ING
Hide quick links:
Advertisement
Table of Contents
