Memory Channel Programming - Icom IC-RX7 Instruction Manual

7
MEMORY PROGRAMMING

■ Memory channel programming

q Push and hold [HOLD V] for 1 sec. to select VFO mode.
w Set the desired frequency, if desired:
• Frequency or any other data can be set while in CH program-
ming state.
➥ Select the desired band with [v] or [w].
➥ Set the desired frequency with [DIAL].
➥ Or set the desired frequency with keypad directly.
In this case, the band and frequency settings with
[v]/[w] and [DIAL] as above are not required.
➥ Set other data (e.g. offset frequency, duplex direction,
tone squelch, etc.) in the menu screen.
e Push and hold [ENT MW] for 1 sec. to enter the memory
programming mode.
• 1 short and 1 long beep sound.
• Category selection screen appears.
✔ STORING SEARCHED FREQUENCY:
Another way to store information into memory channels is as
follows:
q Start a search.
• Search pauses when a signal is received.
• Rotate [DIAL] to restart the search.
w Push [HOLD V] to hold the search, if you want to store the
paused frequency into memory channel.
e Push and hold [ENT MW] for 1 sec. to enter the memory
programming mode.
50
r Push [r] or [s] (or rotate [DIAL]) to select the desired
category or "ADDITION," then push [ENT MW].
• When "ADDITION" is selected, new category can be pro-
grammed (see p. 52 for new category programming details).
t Push [r] or [s] (or rotate [DIAL]) to select the desired
group or "ADDITION," then push [ENT MW].
• When "ADDITION" is selected, new group can be programmed
in the category (see p. 53 for new group programming details).
NOTE: The previous selected category or group are
selected automatically when two or more memory channels
are programmed continuously.