Search Edges Programming; (Push [Menu ]), (Push [R]/[S], Then Push [Ent Mw].); Search Menu Can Also Be Entered By Pushing And Holding; [Search] For 1 Sec - Icom IC-RX7 Instruction Manual

6
SEARCH AND SCAN OPERATIONS

■ Search edges programming

Search edges programming can be stored frequency edges,
receiving mode, tuning steps, attenuator ON/OFF and
search name. Any other items than the frequency edges are
not necessary to program. In this case, settings of each fre-
quency band are used to the search.
q Enter "PROGRAM SEARCH" in SEARCH menu.
MENU ➪ SEARCH ➪ PROGRAM SEARCH
(Push [MENU

• SEARCH menu can also be entered by pushing and holding

[SEARCH] for 1 sec.

• Program number selection screen appears.
w Push [r] or [s] several times (or rotate [DIAL]) to select
the desired program number, then push [ENT MW] to
enter the program.
NO. MENU
DIAL
CLR ENT
SQL MW
HOLD V 1 2 3
4 5 6
SCAN
7 8 9
SEARCH
.
0
SKIP
ATT
30
]), (Push [r]/[s], then push [ENT MW].)
MENU
ENT
Push
MW
• EDIT
e Push [s] once (or rotate [DIAL]) to select "EDIT," then
push [ENT MW] (or [w]).
r Set the desired edge frequencies either "LOW" or "HIGH."
• Push [s] once or twice (or rotate [DIAL]) to select the item.
• Other items cannot be programmed until these frequencies are input.
LOW/HIGH
q Push [ENT MW] (or [w]) to enter the frequency input.
w Edit the desired frequency with keypad (pgs. 20, 21).
ENT
MW
e Push [r] or [s] to select another edge, then edit dif-
ferent frequency.