Programming A Memory Channel - Icom IC-R2500 Instruction Manual

■ Programming a memory channel

VFO settings, including the set mode contents such as sub-
audible tone frequency, offset and scan skip information can
be programmed into a memory channel.
qSet the desired frequency in the desired band (left or right).
➥ Push the desired band's [VFO/MR•S.MW] once or twice
to select VFO mode.
➥ Set the frequency using the same band's [DIAL].
➥ Set other data (e.g. tone frequency, duplex information,
etc.) if required.
wPush and hold the same band's [VFO/MR•S.MW] for
1 sec. to enter select memory write mode.
• "!" indicator and the memory channel number blink.
[EXAMPLE]: Programming 145.800 MHz into memory channel 20 (blank channel).
Push VFO/MR
S.MW
Rotate
Rotate for setting frequency, etc.
VFO/MR
Push for 1 sec. and continue to push
S.MW
Beep
Beep
Beep
MEMORY OPERATION
eRotate the same band's [DIAL] to select the memory chan-
nel to be programmed.
• Memory channels not yet programmed are blank.
r Push and hold [VFO/MR•S.MW] for 1 sec. to program.
• 3 beeps sound
• Memory channel number automatically increases when contin-
uing to push [VFO/MR•S.MW] after programming.
✔CONVENIENT
Memory programming can be made quicker by copying mem-
ory information to different memory channels (p. 27).
Push VFO/MR for 1 sec.
S.MW
Beep
Beep
➠
VFO/MR
Release
S.MW
Beep
5
5
24