Fader (Setting The Fader Curve); How To Adjust The Crossfader Torque - Denon FN-X1700 Owner's Manual

FADER (setting the fader curve)

1
Channel Fader
CH FADER CONTOUR
When the
counterclockwise, the curve will have characteristics
that rise gradually; conversely, when it is turned
clockwise, it will have characteristics that rise sharply.
At the center position, curve characteristics between
the two will be produced.
* The same curve characteristics apply to channels 1
to 4.
2
Crossfader
CH FADER CONTOUR
When the
counterclockwise, the curve will have characteristics
that will rise gradually; conversely, when it is turned
clockwise, it will have characteristics that rise sharply,
and cut-in and cut-out operations will be performed.
At the center position, curve characteristics between
the two will be produced.
12

How to adjust the Crossfader torque

1
Remove the rubber cap of the front panel.
control is turned
2 Crossfader
Move the
head becomes visible.
3
Insert a screwdriver, and adjust the sliding torque.
When the screw is turned clockwise: The sliding torque
is increased so that the Crossfader moves more stiffly.
When the screw is turned counterclockwise: The
sliding torque is decreased so that the Crossfader
control is turned moves more easily.
4
Put the rubber cap of the front panel back in its
place.
NOTE
•
The Crossfader has a high-precision construction: As such, tightening
the screw with too much force or loosening it excessively may result
in damage or adversely affect performance.
to the far right until the screw