Table of Contents
Advertisement
Basic Operations
Preparations
1
POWER switch
Set the
to ON.
2
SOURCE SELECT
Use the
controls to select the sources
(LN1–LN4, D1–D4, USB) of channels 1 to 4 which are
to be used.
CD/PHONO line input selector
Use the
lines to set the CD or PHONO as the line input.
3
Check the level meter, and adjust the input levels using
channel input level
the
controls (LEVEL controls).
4
Adjust the sound quality using the HI, MID, LOW
channel isolator EQ
controls.
5
Determine where the channel signals are to be
CROSSFADER ASSIGN
assigned using the
(A/THRU/B).
Set these switches to the THRU position if the
Crossfader
is not going to be used.
6
Adjust the volume level using the
Crossfader
.
7
Adjust the output level using the
control.
8
MIC (mic input)
1
When using a microphone, press the
button to set it to ON.
2
Adjust the MIC1 volume level using the
control, and adjust the MIC2 volume level using the
MIC2 TRIM
buttons of the
While inputting the audio signals to the unit, monitor
the LEDs on the SIG/PK (signal/peak) meter. If
the LEDs occasionally light up red but there is no
distortion and the LEDs then light up amber, the
suitable level has been reached as a result of the
adjustment process.
3
Adjust the sound quality using the
(HI/LOW).
switches
4
When the
outputs except the mic sound will be attenuated when
the signals from the microphone are supplied.
5
To add the effect functions to the mic input, set the
Channel Fader
and
Mic EFX INS
MASTER LEVEL
Ducking function
This function detects the mic input and attenuates the level of the
music signals in the master output. It prevents the sound from
the microphone from being drowned out by the music when a
microphone is used.
1
To enable the ducking function, set the
OFF
button to ON. The LED in the button will light.
2
The attenuation level of the master output while the
ducking function is operating can be set within a
range from –30 dB +/–10 dB in the Utility mode.
MIC1
MIC2
or
MIC1 TRIM
control.
MIC EQ
controls
DUCKING ON/OFF
button is set to ON, all
buttons to ON.
DUCKING ON/
MONITOR (headphones output)
1
Select the source to be monitored using the
buttons of the channels. When a source is selected, the
CUE
LED in the
button lights.
CUE monitoring for channels 1 to 4 as well as EFX 1
and EFX 2 can be selected.
2
Selecting the STEREO or SPLIT CUE mode.
SPLIT CUE
Use the
button to select the STEREO or
SPLIT CUE mode. When the mode is selected, the
SPLIT CUE
LED in the
button lights.
In the SPLIT CUE (monaural) mode, the signals
selected for cue are output to the left channel speaker
of the headphones, and the master signals are output
to the right channel speaker.
In the STEREO mode, the master signals and signals
selected for cue are output in stereo.
3
headphones PAN
Use the
control to adjust the balance
between the cue signals and master output signals.
When it is turned counterclockwise, only the cue
signals are output from the headphones; conversely,
when it is turned clockwise, only the master output
signals are output.
4
HEADPHONES LEVEL
Use the
control to adjust the
headphones output to the desired level.
CUE
Advertisement
Table of Contents
