Fader Curve Adjustment; Adjusting The Cross Fader Torque; Usb Settings; Computer Os Settings - Denon DN-X600 Owner's Manual

Fader curve adjustment

Adjusts the startup response of the channel fader/cross fader.
n Adjust the channel fader curve
Intermediate curve
characteristics.
Slow startup curve
characteristics.
• CH1 and CH2 have the same curve characteristics.
n Adjust the cross fader curve
Sharp startup
characteristics, with cut-
in/cut-out.
Set the cut position of the
Slow startup curve
cross fader.
characteristics.
(11 levels: CP1-CP11)
(16 levels)
13

Adjusting the cross fader torque

1
Remove the rubber cap on the front panel.
Fast startup curve
characteristics.
2
Move the cross fader to the far right edge so that the
screwdriver will line up with the screw head inside.
3
Using a Phillips screwdriver, adjust the sliding
torque.
• Rotate to the right:Increases the sliding torque so that the
cross fader resistance is increased.
• Rotate to the left:Decreases the sliding torque so that the
cross fader resistance is decreased.
4
After completing the adjustment, replace the rubber
cap on the front panel.
NOTE
The cross fader is constructed of precision parts. Over tightening or
over loosening the cross fader may affect the performance of the
cross fader, or may damage it.
Set the cross fader to
"THRU".
Rubber cap
Small (+) srcewdriver

USB settings

EFX INS
TAP
SEND/RETURN
MASTER
EFX CUE

Computer OS settings

Before connecting a computer to this unit, set the OS of the computer
that you want to connect with this unit.
• The default setting is "PC".
• Settings cannot be changed when the computer is connected.
1
EFX CUE
While pressing , press
The mode changes to OS setting mode.
2
Press BEAT o, p to select the OS.
(Windows OS)
3
Press TAP .
The OS setting is entered.
SEND/RETURN
• To cancel the settings, press
POWER
BEATo,p
BEAT
o, p.
(Mac OS)
.