DJ MIXER DN-X400 OPERATING INSTRUCTIONS GEBRUIKSAANWIJZING BEDIENUNGSANLEITUNG BRUKSANVISNING MODE D’EMPLOI INSTRUCCIONES DE OPERACION L/CUE LINE1 LINE3 PHONO1/LINE5 PHONO2/LINE7 R/PGM ON/OFF LINE2 LINE4 LINE6 LINE8 LEVEL GAIN GAIN GAIN GAIN MASTER MIC POST +10dB +10dB +10dB +10dB -12dB +12dB ON/OFF -26dB...
Canadian Interference-Causing Equipment situated on a bed, sofa, rug, or similar surface that may If problems occur, contact your DENON dealer. 19. Damage Requiring Service – The appliance should be Regulations. block the ventilation openings; or, placed in a built-in serviced by qualified service personnel when: 3.
Page 3
ENGLISH DEUTSCH FRANÇAIS ESPAÑOL NEDERLANDS SVENSKA NOTE ON USE / HINWEISE ZUM GEBRAUCH / FRONT PANEL DIAGRAM / VORDERES BEDIENFELD-SCHEMA / OBSERVATIONS RELATIVES A L’UTILISATION / NOTAS SOBRE EL USO / SCHEMA DU PANNEAU AVANT / DIAGRAMA DEL PANEL FRONTAL / ALVORENS TE GEBRUIKEN / OBSERVERA OVERZICHT VAN VOORPANEEL / FRONTPANELEN L/CUE...
Page 4
• DECLARATION OF CONFORMITY • DECLARACIÓN DE CONFORMIDAD We declare under our sole responsibility that this Declaramos bajo nuestra exclusiva responsabilidad product, to which this declaration relates, is in que este producto al que hace referencia esta conformity with the following standards: declaración, está...
NOTE: the signal of Mic is output to all the outputs Clipping may occur if adjustments are set to When the DN-X400 is mounted inside a coffin or DJ regardless of setting the Main Mic and the harsh. booth, we recommend leaving a 3 cm blank space Post Mic.
Page 6
Inputs for any line level device. MAIN OUT (BALANCED) connectors MONO Program to the right. • When the green indicator is lit, the DN-X400 is • These XLR type connectors provide a Ch 1, 2 FADER output jacks • In the STEREO mode, the meter indicates the ready to go.
Use high-quality, audio cables. attention to L and R position of jacks, on both the and then input units. 3. Do not use excessively long cables. Be sure plugs DN-X400 and outboard gear. jacks securely fastened. Loose...
Fader jack Fader jack Move the source input fader controlled. (Ch. fader) of CH-1 or CH-2 DN-X400 control all the way to the Slide the Crossfader all the way in direction bottom. L/CUE opposite the source you want to start. (In the...
ENGLISH TRACK MARK SPECIFICATIONS • CD category digital signals are output from the DN-X400’s digital outputs. Track numbers can be added at any GENERAL position during recording of these signals onto a digital recorder. Dimensions: 482 (W) x 105 (H) x 177 (D) mm (without feet) •...
Page 10
14-14, AKASAKA 4-CHOME, MINATOKU, TOKYO 107-8011, JAPAN Telephone: (03) 3584-8111 Printed in Japan 511 3835 002...