Machine Settings; Important Notice - Electrolux EDH97950W User Manual

22 machine settings electrolux

Machine settings

Buzzer permanent on/off
Adjusting the level of conductivity
Water contains a variable quantity of limestone
and mineral salts of which quantities
vary according to geographical locations thus
varying its conductivity values.
Relevant variations of the conductivity
of the water compared to those prefixed by
the factory could slightly influence the residual
moisture of the laundry at the end of the cycle.
Your dryer allows you to regulate the sensitivity
of the drying sensor based on conductivity
values of the water.
Service
In the event of technical faults, please first
check whether you can remedy the problem
yourself with the help of the operating
instructions - see Troubleshooting chapter.
If you were not able to remedy the problem
yourself, please contact the Customer Care
Department or one of our service partners.
In order to be able to assist you quickly, we
require the following information:
– Model description
– Product number (PNC)
– Serial number (S No. is on rating plate
stuck to the product - to find it see
chapter Product description))
Before calling a Service Technician please check carefully the operating instructions,
FOR SERVICE
or to find the address of your nearest
state service centre in Australia
PLEASE CALL 13 13 49
For the cost of a local call (Australia only)
FOR SERVICE
or to find the address of your nearest
authorised service centre in New Zealand
FREE CALL 0800 10 66 10
(New Zealand only)
EMAN_Energy Star_0409.indd 22
The alarm is by default always off. To set permanent alarm on (off):
1. Turn the program selector to any program.
2. Press simultaneously the Dryness and Long anticrease buttons
and hold down for approx. 5 seconds.
1. Turn the program selector to any program.
2. Press simultaneously the Long anticrease and Start/Pause
buttons and hold down for approximately 5 seconds.
3. Press the Start/Pause button until you set desired level:
– low conductivity <300 μS/cm
– medium conductivity 300-600 μS/cm
– high conductivity >600 μS/cm
4. To memorise setting press simultaneously the Long anticrease
(Long anticrease) and Start/Pause (Start/Pause) buttons
or turn knob to
So that you have the necessary reference
numbers from your appliance at hand, we
recommend that you write them in here:

Important Notice

and the warranty terms and conditions.
SERVICE AUSTRALIA
ELECTROLUX HOME PRODUCTS
www.electrolux.com.au
SERVICE NEW ZEALAND
ELECTROLUX HOME PRODUCTS
www.electrolux.co.nz
off position
– Type of fault
– Any error messages displayed by the
appliance
Model description:
PNC:
S No:
FOR SPARE PARTS
or to find the address of your nearest
state spare parts centre in Australia
PLEASE CALL 13 13 50
For the cost of a local call (Australia only)
FOR SPARE PARTS
or to find the address of your nearest
state spare parts centre in New Zealand
FREE CALL 0800 10 66 20
(New Zealand only)
12/5/09 11:46:34 AM