Lighting Your Grill; Standard Lighting Procedure; Rotisserie Burner(S) - Kalamazoo Outdoor Gourmet K500HB Use And Care Manual

Lighting Your Grill

Before lighting your grill, be sure you have followed the instructions in this
Use and Care Guide regarding proper setup, placement, gas connections leak
testing (see page 13) and safe operation, all of which precede this page.
IMPORTANT:
Follow leak testing procedures before using the grill.

Standard Lighting Procedure:

Main Burners
1.
Open the grill hood
2. Pull open the Hybrid Fire Grilling Drawer approximately 2
CAUTION
inches so that you can easily see inside the flash tube (see
1. Read instructions before lighting.
Figure 12:L page 25).
2. Open lid during lighting.
3. If ignition does not occur in 5 seconds, turn the burner control(s) off,
3.
Make sure all control knobs are in the OFF position.
wait 5 minutes, and repeat the lighting procedure.
4. Turn the main gas supply on.
Key to Burner Control Labels
5.
Keeping your face well away from the unit, watch the end of the
flash tube (see Figure 12:L page 25). Press in the IGNITION BURNER
control knob (see Figure 18:A page 28) for 2 seconds. You should see
the electronic ignition coil glowing inside the flash tube. While continuing to
Ignition Burner Main Burner Rotisserie Burner
press in the control knob, turn it to the HIGH position. Ignition should take place within 4 to 5 seconds.
Lighting Instructions
You will see and hear the flash at the end of the flash tube when the ignition burner ignites. If the
Main Burners
burner does not light within 4 to 5 seconds, turn the knob to the OFF position and wait 5 minutes for
To light the main burners, you must first light the ignition burner.
the gas to dissipate before trying again. If you do not see the electronic ignition coil glowing inside
Press in the ignition burner control and hold for 1 second.
the flash tube, refer to the troubleshooting section of this Use and Care Guide. You can confirm the
While continuing to press in the control, turn to the HIGH position.
Continue pressing in until the burner lights. If ignition does not occur
ignition burner is operating by looking down into the grill through the view port. The view ports are
within 5 seconds, turn the ignition burner control off, wait 5 minutes,
and repeat the lighting procedure.
aligned with holes in the Hybrid Fire Grilling Drawers.
Once the ignition burner is lit, turn on any main burner to the HIGH
position. The main burner will light from the ignition burner. If ignition
6. To light any MAIN BURNER (see Figure 11:J page 25), first make sure the ignition burner is lit (see
does not occur within 5 seconds, turn the main burner controls off, wait
5 minutes, and repeat the lighting procedure.
Figure 11:K page 25) and the IGNITION BURNER control knob is at the HIGH position. Open the grill
See your Use and Care Guide for manual lighting instructions.
hood. Turn any MAIN BURNER control knob to the HIGH position. Ignition should take place within 4

Rotisserie Burner(s)

to 5 seconds. Watch through the grilling surface and Hybrid Fire Grilling Drawer to confirm the MAIN
Main Burner Rotisserie Burner Cooktop Burner
Press in the rotisserie burner control and hold for 1 second.
BURNER is lit. If the burner does not light within this time, turn the MAIN BURNER control knob to the OFF
While continuing to press in the control, turn to the HIGH position.
position and wait 5 minutes for the gas to dissipate before trying again. Each MAIN BURNER must be lit
Continue pressing in until the burner lights. If ignition does not occur
within 5 seconds, turn the rotisserie burner control off, wait 5 minutes,
from the IGNITION BURNER. No MAIN BURNER will light unless the IGNITION burner is burning.
and repeat the lighting procedure.
See your Use and Care Guide for manual lighting instructions.
Rotisserie Burner(s)
Cooktop Burners
Remove the burner cover before operation.
1. Open the grill hood
Press in the cooktop burner control and turn to the HIGH position.
Continue pressing in until the burner lights. If ignition does not occur
2.
Make sure all control knobs are in the OFF position.
Rotisserie Burner Cooktop Burner
within 5 seconds, turn the cooktop burner control off, wait 5 minutes,
and repeat the lighting procedure.
3. Turn the main gas supply on.
See your Use and Care Guide for manual lighting instructions.
4.
Keeping your face well away from the unit, press in the ROTISSERIE BURNER control knob (see Figure
18:C page 28) for 2 seconds. You should see the electronic ignition coil glowing in front of the rotisserie
burner. While continuing to press in the control knob, turn it to the HIGH position. Ignition should take
place within 4 to 5 seconds. If the burner does not light within 4 to 5 seconds, turn the knob to the OFF
position and wait 5 minutes for the gas to dissipate before trying again. If you do not see the
electronic ignition coil glowing, refer to the troubleshooting section of this Use and Care Guide.
1.800.868.1699
Do not use the grill if the odor of gas is present at any time.
Cooktop Burner
Ignition Burner
CAUTION
1. Read instructions before lighting.
2. Open lid during lighting.
3. If ignition does not occur in 5 seconds, turn the burner control(s) off, wait 5
minutes, and repeat the lighting procedure.
Key to Burner Control Labels
Ignition Burner
Lighting Instructions
Main Burners
CAUTION
To light the main burners, you must first light the ignition burner.
1. Read instructions before lighting.
Press in the ignition burner control and hold for 1 second.
2. Open lid during lighting.
While continuing to press in the control, turn to the HIGH position. Continue pressing
3. If ignition does not occur in 5 seconds, turn the burner control(s) off, wait 5
in until the burner lights. If ignition does not occur within 5 seconds, turn the ignition
minutes, and repeat the lighting procedure.
burner control off, wait 5 minutes, and repeat the lighting procedure.
Once the ignition burner is lit, turn on any main burner to the HIGH position. The main
Key to Burner Control Labels
burner will light from the ignition burner. If ignition does not occur within 5 seconds,
turn the main burner controls off, wait 5 minutes, and repeat the lighting procedure.
See your Use and Care Guide for manual lighting instructions.
Rotisserie Burner(s)
CAUTION
Press in the rotisserie burner control and hold for 1 second.
Ignition Burner Main Burner
1. Read instructions before lighting.
While continuing to press in the control, turn to the HIGH position. Continue pressing
in until the burner lights. If ignition does not occur within 5 seconds, turn the
2. Open lid during lighting.
rotisserie burner control off, wait 5 minutes, and repeat the lighting procedure.
Lighting Instructions
3. If ignition does not occur in 5 seconds, turn the burner control(s) off, wait 5
See your Use and Care Guide for manual lighting instructions.
minutes, and repeat the lighting procedure.
Main Burners
To light the main burners, you must first light the ignition burner.
Key to Burner Control Labels
Cooktop Burners
Press in the ignition burner control and hold for 1 second.
Press in the cooktop burner control and turn to the HIGH position. Continue pressing
in until the burner lights. If ignition does not occur within 5 seconds, turn the cooktop
While continuing to press in the control, turn to the HIGH position. Continue pressing
burner control off, wait 5 minutes, and repeat the lighting procedure.
in until the burner lights. If ignition does not occur within 5 seconds, turn the ignition
burner control off, wait 5 minutes, and repeat the lighting procedure.
See your Use and Care Guide for manual lighting instructions.
Once the ignition burner is lit, turn on any main burner to the HIGH position. The main
burner will light from the ignition burner. If ignition does not occur within 5 seconds,
Main Burner
turn the main burner controls off, wait 5 minutes, and repeat the lighting procedure.
See your Use and Care Guide for manual lighting instructions.
Lighting Instructions
Rotisserie Burner(s)
Main Burners
Press in the rotisserie burner control and hold for 1 second.
To light the main burners, you must first light the ignition burner.
While continuing to press in the control, turn to the HIGH position. Continue pressing
Press in the ignition burner control and hold for 1 second.
in until the burner lights. If ignition does not occur within 5 seconds, turn the
While continuing to press in the control, turn to the HIGH position. Continue pressing
rotisserie burner control off, wait 5 minutes, and repeat the lighting procedure.
in until the burner lights. If ignition does not occur within 5 seconds, turn the ignition
See your Use and Care Guide for manual lighting instructions.
burner control off, wait 5 minutes, and repeat the lighting procedure.
Once the ignition burner is lit, turn on any main burner to the HIGH position. The main
Cooktop Burners
burner will light from the ignition burner. If ignition does not occur within 5 seconds,
turn the main burner controls off, wait 5 minutes, and repeat the lighting procedure.
Press in the cooktop burner control and turn to the HIGH position. Continue pressing
in until the burner lights. If ignition does not occur within 5 seconds, turn the cooktop
Main Burner Rotisserie Burner
Rotisserie Burner
Rotisserie Burner Cooktop Burner
Ignition Burner
View Port
Cooktop Burner
Cooktop Burner
31