Lighting Your Grill - Kalamazoo K750GS Use And Care Manual

Lighting Your Grill

Before lighting your grill, be sure you have followed the instructions in this Use and Care
Guide regarding proper setup, placement, gas connections leak testing and safe operation,
all of which precede this page.
IMPORTANT:
Do not use the grill if the odor of gas is present at any time. Follow leak
testing procedures before using the grill.
Standard Lighting Procedure:
Starter Burners
1.
Remove grill cover (Figure 15:Z).
2.
Raise grill rack (Figure 7:C) so that you have a clearer view of the burners (Figure 8:E,H)
3.
Make sure all control knobs (Figure 16:A,B,G,H) are in the OFF position.
4. Turn the main gas supply on.
5. Keeping your face well away from the firebox. Press in the REAR STARTER BURNER control knob (see
Figure 16:B) for 2 seconds to activate the hot surface ignition coil (Figure 8:J). While continuing to
press in the control knob, turn it to the HIGH position. Ignition should take place within 4 to 5 seconds.
If the burner does not light within 4 to 5 seconds, turn the knob to the OFF position and wait 5
minutes for the gas to dissipate before trying again.
6. Repeat the process to light the front starter burner. Keeping your face well away from the firebox. Press
in the FRONT STARTER BURNER control knob (see Figure 16:A) for 2 seconds to activate the hot surface
ignition coil (Figure 8:G). While continuing to press in the control knob, turn it to the HIGH position.
Ignition should take place within 4 to 5 seconds. If the burner does not light within 4 to 5 seconds, turn
the knob to the OFF position and wait 5 minutes for the gas to dissipate before trying again.
Cooktop Burners
1. Remove the stainless steel cover from the cooktop burners (see Figure 12:T).
2.
Make sure all control knobs are in the OFF position.
3.
Turn the main gas supply on.
4.
Keeping your face well away from the unit, press in the COOKTOP BURNER control knob (see Figure
16:G,H). You should hear a rapid clicking noise from the electronic ignition. While continuing to press
in the control knob, turn it to the HIGH position. Ignition should take place within 4 to 5 seconds. If the
burner does not light within 4 to 5 seconds, turn the knob to the OFF position and wait 5 minutes for
the gas to dissipate before trying again. If you do not hear clicking from the electronic ignition system,
refer to the troubleshooting section of this Use and Care Guide.
5. NEVER PLACE THE COOKTOP BURNER COVER OVER THE COOKTOP BURNERS WHILE THE
BURNERS ARE IN OPERATION.
24 KalamazooGourmet.com