Unix Configuration; Before Setup; Using The Lp/Lpr Commands; Using The Rsh/Rcp/Ftp Commands - Lanier AP4510 Setup Manual

This section explains how to set up a network printer and check the print status
using UNIX.
Limitation
❒ To print from a UNIX workstation, use the file that the printer supports.

Before Setup

Setting up can vary depending on the printing commands. Please make sure to
make the settings accordingly.

Using the lp/lpr commands

A A A A
Use the installation shell script to register the device option, as well as the
printer host name and the IP address.
⇒ p.2 "Using the Installation Shell Script"
B B B B
Start printing.
⇒ p.11 "Printing Method"

Using the rsh/rcp/ftp commands

A A A A
Edit the host file to register the printer host name and the IP address.
B B B B
Start printing.
⇒ p.11 "Printing Method"
Reference
See p.6 "After Executing Installation Shell Script" for host file editing.
Note
❒ If you cannot edit the host file, use the install shell script to register the host
name.

1. UNIX Configuration

1