Lanier AP4510 Setup Manual page 285

E E E E
Click the IPX address of the Network Interface Board which is to be config-
ured, and then click [Next >].
Note
❒ If you do not know which Network Interface Board you are configuring,
see the network configuration page to check the MAC address (Network
Address).
F F F F
Make sure that the MAC address and IPX address are correct, and then click
[Finish].
The [NIB Setup Tool] window appears.
G G G G
Click [Configure].
The property sheet appears.
H H H H
Click the [General] tab, and then type the name of the print server into the
[Device Name] box.
I I I I
Click the [NetWare] tab, and then make the following settings.
A A A A Select [Bindery].
B B B B In the [File Server Name:] box, type the name of the file server in which a
print server is to be created.
Click [Browse] to select a file server among those listed in the [Browse] dia-
log box.
C C C C Click [OK] to close the property sheet.
D D D D After the confirmation dialog box appears, click [OK].
J J J J
On the [NIB] menu, click [Exit] to exit the NIB Setup Tool.
K K K K
Type "PCONSOLE" from the command prompt.
F:> PCONSOLE
L L L L
Create a print queue as follows:
Note
❒ If you use a currently defined print queue, go to step
A A A A From the [Available Options] menu, select [Print Queue Information], and then
press the { { { { ENTER} } } } key.
B B B B Press the { { { { INSERT} } } } key, and then type a print queue name.
C C C C Press the { { { { ESC} } } } key to return to the [Available Options] menu.
NetWare 3.x - Advanced Settings
M
.
4
45