Lanier AP4510 Setup Manual page 130

Troubleshooting
❖ ❖ ❖ ❖ Alert Messages
Messages/Second messages
Add Staples
Call Service: EC
Power Off On
/If Error Reoccur
Call Service
Change Setting
Bypass Tray
/Paper Size
Paper Type
5
Change Setting
LCT
/Paper Size
Paper Type
56
Description
The staples are almost run
out.
An error has occurred in the
printer.
The paper type and size set-
ting on the tray differs from
that of actual paper type and
size in the tray.
The paper type and size set-
ting on the tray differs from
that of actual paper type and
size in the tray.
Solution
Replace the staple refill with a
new one. See p.91 "Adding
Staples".
First, turn the power switch
off and then on. If the message
appears again, call your sales
or service representative.
Load { paper size and type }
paper with the selected feed
direction into tray. Printing
will not automatically resume
if the paper type, size and di-
rection setting is incorrect.
There are two methods to
resume printing.
A
Use the control panel to set
the correct paper type, size
and direction of the paper
in tray.
Press { { { { Form Feed} } } } and se-
B
lect the tray with the con-
trol panel.
Load { paper size and type }
paper with the selected feed
direction into tray. Printing
will not automatically resume
if the paper type, size and di-
rection setting is incorrect.
There are two methods to
resume printing.
A
Use the control panel to set
the correct paper type, size
and direction of the paper
in tray.
Press { { { { Form Feed} } } } and se-
B
lect the tray with the con-
trol panel.