Netware 3.X - Advanced Settings; Setting Up As A Print Server - Lanier AP4510 Setup Manual

NetWare Configuration

NetWare 3.x - Advanced Settings

The actual procedures for configuring the machine vary depending on whether
the Network Interface Board is configured as a print server or as a remote print-
er. This section describes how to configure the machine in the NetWare 3.x en-
vironment.
Basic Procedure
Install the NIB Setup Tool
Print Server
4 Configure the Network Interface Board
Configure the NetWare
Preparation
The following procedures use the Property Sheet method in configuring the
Network Interface Board. If you configure the Network Interface Board as a
NetWare print server for the first time, we recommend you use the Wizard
method. ⇒ p.41 "Quick Setup Using the NIB Setup Tool Wizard"
Note
❒ This section assumes NetWare is functional and that the necessary environ-
ment for the NetWare Print Service is available.

Setting Up as a Print Server

A A A A
Log on to the file server as a Supervisor or a Supervisor equivalent.
B B B B
Run the NIB Setup Tool.
Reference
⇒ p.40 "Running the NIB Setup Tool"
C C C C
Click [Property Sheet] and click [OK].
The [NIB Setup Tool - Network board list] dialog box of the Network Interface
Board appears.
D D D D
Click [IPX protocol].
44
Remote Printer
Start the print server