Configuring Netbeui For Printing - Lanier AP4510 Setup Manual

Windows NT 4.0 Configuration
B B B B
Configure the TCP/IP protocols with the appropriate IP address, subnet
mask and other settings.
Check with the network administrator that the settings are correct.
C C C C
Click the [Services] tab, and then make sure that "Microsoft TCP/IP Print-
ing" is installed.
If "Microsoft TCP/IP Printing" is not installed, click [Add] on the [Services ]
tab, to install it. For more information about installing and configuring net-
work services, see Windows NT Help.
3

Configuring NetBEUI for Printing

These instructions are for configuring the Network Interface Board and Win-
dows NT to use the NetBEUI protocol.
Configuring the machine
Configure the machine to use the NetBEUI protocol.
• Make sure that the NetBEUI protocol is set to active. (The default is active.)
Reference
For more information about how to make the above settings, see the Setup
Guide.
Configuring a Windows NT computer
Install the NetBEUI protocol on the Windows NT computer, and then change the
LAN adapter number (Lana Number).
A A A A
Open [Control Panel], and then double-click the [Network] icon. Make sure
that "NetBEUI Protocol" is listed in the [Network Protocols] box on the [Proto-
cols] tab.
Note
❒ If the NetBEUI protocol is not installed, click [Add] on the [Protocols] tab to
install it. For more information about installing the NetBEUI protocol, see
Windows NT Help.
B B B B
Change the Lana Number. Click the [Services] tab, click "NetBIOS Inter-
face" in the [Services] tab, and then click [Properties].
C C C C
Click the Lana Number corresponding the Nbf protocol of the [Network
Route] headline, and then click [Edit].
28