Moving And Transporting The Printer; Moving The Printer - Lanier AP4510 Setup Manual

Appendix

Moving and Transporting the Printer

R CAUTION:
• When moving the machine, each person should hold the handles that are
located on opposite sides, and then lift it slowly. Lifting it carelessly or drop-
ping it may cause an injury.
• When you move the printer, remember to unplug the power cord from the
wall outlet to avoid a fire or an electric shock.
• When you pull out the plug from the socket, grip the plug, not the cord, to
avoid damaging the cord and causing a fire or an electric shock.
Note
❒ The printer weighs approximately 63 kg (138.9 lb.).
❒ Repack the printer in its original packing materials for transporting.
Important
❒ Be sure to disconnect all cables from the printer before transporting it.
❒ The printer is a precision piece of machinery. Take care to avoid damage dur-
ing shipment.

Moving the Printer

7
R CAUTION:
• When lifting the machine, use the grips on both sides. Otherwise the printer
could break or cause an injury if dropped.
• Before moving the machine, unplug the power cord from the wall outlet. If
the cord is unplugged abruptly, it could become damaged. Damaged plugs
or cords can cause an electrical or fire hazard.
Moving the printer in a short distance
A A A A
Be sure to check the following points:
• The power switch is turned off.
• The power cable is unplugged from the wall outlet.
• The interface cable is unplugged from the printer.
B B B B
If the external options are installed, remove them.
C C C C
Lift the printer with two people by holding the handles, and then move it
horizontally to the place where you want to install it.
138