Making Network Settings For Using Netware - Lanier lp145n Hardware Manual

E
Select [DHCP] using {T} or {U}, and then press the {q Enter} key.
F
Select [On] or [Off]using {T} or {U}, and then press the {q Enter} key.
The address will be detected by the printer.
The default setting is [Off].
G
Press the {Menu} key to return to the initial screen.
H
Print a configuration page to confirm the settings made.
Reference
For details about printing the configuration page, see "Printing the Test
Page", Quick Installation Guide.

Making Network Settings for Using Netware

If you use NetWare, select the frame type for NetWare.
Select one of the items below if necessary.
• Auto (Default)
• Ethernet II
• Ethernet 802.2
• Ethernet 802.3
• Ethernet SNAP
Important
❒ Usually, use the default setting ("Auto"). When you first select "Auto", the
frame type detected by the printer is adopted. If your network can use more
than two frame types, the printer may fail to select the correct frame type if
"Auto" is selected. In this case, select the appropriate frame type.
Ethernet Configuration
55
4