Table of Contents
Advertisement
5. TROUBLESHOOTING
5.1
Common Problems & Solutions
Problems
Does not turn on
No image
Image is blurred
Image is too dark
No sound
Remote control does not
work
Status indicator is lit or
blinking
31
Check These Items
"
Check that the power cable is plugged in and that power switch on the
side of projector is switched on, and power button on the projector
control keypad or remote control is pressed on.
"
Check that the projector is on.
"
Use the menu to select the source (Composite video, S-Video,
Component video, Analog RGB, Component video or DVI). See page 25.
"
Ensure the cables are connecting correctly.
"
Use the menu to adjust the brightness and contrast. See page 21. Or
reset the settings to factory preset level using the Factory Reset option
on the Utilities menu. See page 24.
"
Remove the lens cap.
"
Adjust the focus. See page 17.
"
Ensure the distance between the projector and the screen is within the
focus range of the lens. See page 4.
"
Adjust the contrast or brightness in the Image menu properly. See page
21.
"
Ensure the cables are connecting properly. See page 10.
"
Make sure the Mute option in Audio menu is selected Off. See page 25.
"
Install new batteries. See page 16.
"
Make sure there is no obstacles between you and the projector
receivers.
"
Stand within the distance of remote control usage range. See page 20.
"
See the Power and lamp indicator message chart on page 15.
Advertisement
Table of Contents
