Turning On & Turning Off The Projector - Christie Projector User Manual

Operation
3.2 Turning On &
Turning Off The
Projector
LAMP
W
SOURCE
MENU
POWER
LASER
MENU
KEYSTONE ZOOM
DATA
AUTO
VIDEO FREEZE
LM
RM
UP VOL+
LEFT RIGHT
DOWN VOL-
15
Before turning on the projector, make sure the video source is turned on and
the lens cap is removed. Connect the power cord to the projector.
Turning On the Projector:
1. Turn on the main power switch on the side of the projector, the projector
will go into its standby mode and the power indicator will glow orange.
2. Press the Power button on the projector control keypad or on the remote
control, the power and lamp indicator will glow green and the projector
will be ready to use.
Turning Off the Projector:
1. Press the Power button on the projector control keypad or on the remote
control, the message as below will show on screen. Press the Left button
to move the cursor to "Power Off" and press Menu button to turn off the
projector, and the power indicator will glow orange. After the projector is
turned off, the cooling fan will continue to run for 120 seconds and then
stop.
POWER BUTTON WAS PUSHED!
Move the cursor to "Power Off"
Power Off
NOTE: Do not disconnect the power cord or switch off the main power
switch when the cooling fan is still running.
NOTE: If mis-press the Power button, move the cursor to "Cancel" by
pressing the Right button and press Menu button to resume. The
message will disappear after 10 seconds if there is no response.
2. Switch off the main power switch on the side of the projector and unplug
the power cord. The power indicator will go out.
Power and Lamp Status Indicators Messages Chart:
Condition Power Indicator
Main power switch on Orange
(side)
Power On Green
Power Standby Orange
Cooling down Flashing green
Lamp life (1500 hrs) Green
System error Orange
Temperature error Orange
Lamp error Orange
Fan error Orange
and press MENU button
to turn projector off.
Lamp Indicator
-
Green
-
-
Flashing Green
Flashing Red
(1 sec interval)
Flashing Red
(2 sec interval)
Flashing Red
(4 secs interval)
Flashing Red
(8 secs interval)
Cancel
Description
Flashing for 120 seconds
Lamp timer, message of "The lamp is
reaching its limit. Please replace the
lamp as soon as possible." appears
on screen when the lamp reaches
1400 hours usage ; "Lamp Expired"
When lamp reaches 1500 hours
usage.
Projector in power standby mode
and cannot be turned on
Projector in power standby mode
and cannot be turned on
Projector in power standby mode
and cannot be turned on
Projector in power standby mode
and cannot be turned on